Operation; I Turning Power On; I Channel Selection - Icom IC-F111S Instruction Manual

I Turning power ON

q Push [
] to turn the power ON.
w If the transceiver is programmed for a start up passcode,
input the digit codes as directed by your Dealer.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are same.
e When all channel indicator LEDs still blink after inputting 4
digits, the input code number is incorrect. Turn the power
off and start over in this case.
KEY
0 1
NUMBER
5 6
2 3 4
7 8 9

OPERATION

I Channel selection

Several types of channel selection are available. The meth-
ods may differ according to your system setup.
NON-BANK TYPE:
Push [CH UP]/[CH DN] to select the desired operating chan-
nel, in sequence; or, push one of the [CH 1] to [CH 4] keys to
select a channel directly.
BANK-TYPE:
Push [BANK] to toggle between bank 1 and 2.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.
2
6