Installing Memory - IBM NetVista X40i User Manual

Installing memory

You can add memory to your computer to increase system performance. Your
computer has two SDRAM DIMM connectors 1 for installing memory, up to
a maximum of 512MB.
To install a DIMM, do the following:
1. Remove the rear computer cover. See "Removing the rear cover" on
page 42.
2. Remove the hard disk drive. See "Removing the hard disk drive" on
page 44.
3. Remove the system board cover. See "Removing the system board cover"
on page 45.
4. Locate the DIMM sockets on the system board. See "System board" on
page 41.
5. Open the module retaining clips on one of the DIMM sockets.
46
User Guide