Head And Neckrest; Tray - Otto Bock Bravo Racer Instructions For Use Manual

Use
2) Place the user in an upright, 90° seated position (if physiologically possible). Ensure that the back is up against
the back support pad (if physiologically possible).
3) Close the buckle.
4) The lap belt should be at an angle of about 60° to the seat bottom. The belt strap should run across the thighs
in front of the pelvic bones (see fig. 23).
Possible errors
• The lap belt is positioned above the user's pelvis in the area of the soft part of the stomach.
• The user does not sit upright in the seat.
• If the lap belt is too loose, the user can shift/slide out to the front.
• During the installation/adjustment, the lap belt is routed over parts of the seating system (e.g. over forearm
supports or seat pads). This causes the lap belt to lose its retaining function.
23

7.15 Head and neckrest

Head/neckrests or headrests make it possible to support the head in case of various severe disability indications.
The head/neckrests or headrests consist of polyurethane foam and can be cleaned with mild soap and water.
The option is installed on the product by qualified personnel if needed and adapted to the requirements of the user.
The user may adjust the movable blocks of the headrest according to his/her preferences.
To do so, adjust the movable blocks into the desired position and tighten the wrench bolts to fix the headrest in
place.

7.16 Tray

WARNING
Inflammable product
Burns due to user error
► The product is flame retardant but nevertheless flammable. Therefore the utmost caution must be exercised in
the vicinity of an open flame.
► Keep away from all ignition sources, especially lit cigarettes.
CAUTION
Improper adjustment
Crushing or pinching due to adjustments which are too tight
► Do not pinch the user when sliding in the product.
CAUTION
Driving with objects on the tray top
Injuries due to unsecured objects
► Remove all objects from the tray top prior to travelling.
24
60°
Bravo Racer