Advertisement
b
1〜2mm
Tightening torque 3.8 N·m (0.38 kgf·m, 2.8 lb·ft)
Tightening torque 1.5 N·m (0.15 kgf·m, 1.1 lb·ft)
2
Tightening torque 0.8 N·m (0.08 kgf·m, 0.59 lb·ft)
INSTALLING THE INCLUDED PARTS
a
c
3
1
1
2
– 8 –
NOTICE
8 Install the button cell battery with the plus
(+) mark facing upward.
8 Check that the O-ring g is properly
installed.
After installing the button cell battery, install the
display unit onto the bracket following the
removal procedure in reverse order.
5. Installing the display unit's
Maintain a clearance of 1 to 2 mm between the
bracket of the compact multifunction meter set
a and the handlebar holder b as shown, install
the set, and then tighten the bolt c to the spec-
ified torque.
After installing, remove the protective film.
6. Installing the front reflector
Install the front reflector 1, stay 2, and screw
3 as shown, and then tighten them together to
the specified torque.
1
Front reflector
2
Stay
3
Screw
TIP
Adjust so that the front reflector 1 faces straight
ahead, then tighten the screw.
7. Installing the bell
Install the bell 1 in the shown, then tighten it
with the screw 2.
1
Bell
2
Screw
1
A
1
A
1
A
1
A
1
A
Advertisement
