REVELTRONICS UTCOMP-3 User & Assembly Manual page 24

Click "Settings" button. Appropriate dialog should popup (similar to that shown in the screenshot below). The program should read the settings from
the device. Some options are dedicated only for UTCOMP-PRO so in UTCOMP-3 may be inactive.
You can save settings to the device by clicking
"Settings -> Save settings to UTCOMP" or using
shortcut "CTRL + S". Success information will be
displayed in status bar. All important settings are
stored in non-volatile memory
remember the settings even after a power failure).
You can set engine settings before assembling.
Other functions left default at the moment. Default
settings can be loaded any time from "Settings ->
Restore default settings" or using "CTRL + ALT +
R" shortcut.
If the device has communicated with a PC and
can read and save new settings it means that the
device is working properly and you can proceed to
its assembly.
Prior to installation, thoroughly
assembly instructions (Chapter 2).
(the device
read the
- 24 -