Installing The Chassis In A Cabinet Or Rack - Cisco MDS 9200 Series Installation Manual

Chapter 2 Installing the Cisco MDS 9200 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
Check for damage and report any discrepancies or damage to your customer service representative. Have
Step 2
the following information ready:
•
•
•
•

Installing the Chassis in a Cabinet or Rack

This section describes how to use the rack-mount kit provided with the switch to install the Cisco MDS
9200 Series into a cabinet or rack that meets the requirements described in
Rack Installation."
Caution If the rack is on wheels, ensure that the brakes are engaged or that the rack is otherwise stabilized.
The rack-mount kit provided with the switch contains the items listed in
the parts listed in
the front rack-mount brackets. If this is the case, you can either install the switch in the rack with just
the front rack-mount brackets, or contact your customer service representative for a current version of
the rack-mount kit.
If you purchased Cisco support through a Cisco reseller, contact the reseller directly. If you purchased
Note
support directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml
Table 2-1
Quantity
Front rack-mount bracket kit
2
12
Cable management bracket kit
2
6
6
Rear rack-mount bracket kit
2
2
OL-19588-01
Cables and connectors
Any optional items ordered
Invoice number of shipper (see packing slip)
Model and serial number of the damaged unit
Description of damage
Effect of damage on the installation
All Cisco MDS 9200 Series switches use the same installation procedure.
Table 2-1, you may have an older version of the rack-mount kit, which only included
Contents of Cisco MDS 9200 Series Rack-Mount Kit
Part Description
Front rack-mount brackets
M4 x 6-mm Phillips countersunk screws
Cable guide
12-24 x 3/4-inch Phillips binder-head screws
10-32 x 3/4-inch Phillips binder-head screws
Long slider rails
Short slider rails

Installing the Chassis in a Cabinet or Rack

Table
Cisco MDS 9200 Series Hardware Installation Guide
Appendix A, "Cabinet and
2-1. If you do not find all
2-5