Installing Front Rack-Mount Brackets For Cabinets With 26 Inches Or Greater Of Rail Spacings - Cisco MDS 9200 Series Installation Manual

Installing the Switch in a Cabinet with Insufficient Front Clearance
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The rack-mount kit provided with the switch contains the items listed in
of the parts listed in
the front rack-mount brackets. If this is the case, you can either install the switch in the rack with just
the front rack-mount brackets, or contact your customer service representative for a current version of
the rack-mount kit.
If you purchased Cisco support through a Cisco reseller, contact the reseller directly. If you purchased
Note
support directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml
Installing Front Rack-Mount Brackets for Cabinets with 26 Inches or Greater of
Rail Spacings
Before installing the switch into the cabinet, the front rack-mount brackets for the Cisco MDS 9200
Series must be installed onto the switch. To install the brackets for cabinets with front-mounting rail to
rear-mounting rail spacing greater than or equal to 26 inches, follow these steps:
Step 1 Install the front rack-mount brackets as follows:
a.
b.
Figure 2-7
1
Cisco MDS 9200 Series Hardware Installation Guide
2-12
Table 2-1, you may have an older version of the rack-mount kit, which only included
Position a front rack-mount bracket against the chassis and align the screw holes as shown in
Figure 2-7. Then attach the front rack-mount bracket to the chassis with six of the M4 screws.
Repeat with the other front rack-mount bracket on the other side of the switch.
Attaching Front Rack-Mount Bracket to the Cisco MDS 9200 Series
M D
S
9 2
1 1 6
i
2
3
4
5
6
7
8
9
10
11
12
13
14
LI N
K G E
1
LI N
K G E
2
Front rack-mount bracket
1
2
2
Screws, M4
Chapter 2 Installing the Cisco MDS 9200 Series
Table 2-1. If you do not find all
OL-19588-01