Leds On Ip Storage Services Module; 32-Port Fibre Channel Storage Services Module - Cisco MDS 9200 Series Installation Manual

Chapter 1 Product Overview
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

LEDs on IP Storage Services Module

Table 1-8
Table 1-8
LED
Status
Link

32-Port Fibre Channel Storage Services Module

The 32-port Fibre Channel Storage Services Module (SSM) for the Cisco MDS 9000 Family supports
up to 32 Fibre Channel ports, provides distributed intelligent storage services, and supports future
storage services.
Cisco MDS 9200 Series switches running Cisco MDS SAN-OS Release 2.x, 3.x, and NX-OS Release
Note
4.1(1b) support the SSM.
OL-19588-01
describes the LEDs for the IPS module.
LEDs for the Cisco MDS 9000 Family IPS Modules
Status Description
Green All diagnostics pass. The module is operational (normal
initialization sequence).
Orange One of the following occurs or occurred:
• The module is booting or running diagnostics (normal
initialization sequence).
The inlet air temperature of the system exceeded the
•
maximum system operating temperature limit (a minor
environmental warning). To ensure maximum product
life, you should immediately correct the environmental
temperature and restore the system to normal operation.
Red One of the following occurred:
The diagnostic test failed. The module is not
•
operational because a fault occurred during the
initialization sequence.
he inlet air temperature of the system exceeded the
• T
safe operating temperature limits of the card (a major
environmental warning). The card shut down to prevent
permanent damage.
Solid Link is up.
green
Flashing Link is up (beacon used to identify port).
green
Solid Link is disabled by software.
yellow
Flashing A fault condition exists.
yellow
Off No link.
Cisco MDS 9200 Series Hardware Installation Guide
Services Modules
1-27