Installing The Shelf Bracket Kit Into A Two-Post Telco Rack - Cisco MDS 9200 Series Installation Manual

Cisco MDS 9000 Family telco and EIA Shelf Bracket
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Installing the Shelf Bracket Kit into a Two-Post telco Rack

Figure A-1
Figure A-1
1
1 Rack-mounting rail (2x)
2 Shelf bracket (2x)
To install the shelf brackets in a telco rack, follow these steps:
Step 1 Position a shelf bracket inside a rack-mounting rail as shown in
front of the shelf bracket with the holes in the rack-mounting rail. Then, attach the shelf bracket to the
rack-mounting rail using a minimum of four 12-24 or 10-24 screws.
Note
Repeat with the other shelf bracket.
Step 2
Step 3 Verify that the shelf brackets are at the same height (using the level or tape measure as desired).
Step 4 Attach the crossbar to the rear of the shelf brackets as shown in
Cisco MDS 9200 Series Hardware Installation Guide
A-6
shows the installation of the shelf bracket kit into a two-post telco rack.
Installing the Shelf Bracket Kit into a telco Rack
2
The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the
rack-mounting rail (the hole immediately above the 1/2-in. spacing).
3
4
3 10-32 screws (2x)
4 Crossbar
Appendix A Cabinet and Rack Installation
Figure A-1. Align the screw holes at the
Figure A-1, using the 10-32 screws.
OL-19588-01