7B.6 Drive Reference Information; 7B.6.1 Using The Programmer - O. Thompson Microflite Ultra 2000 Installation & Adjustment Manual

Microflite Ultra 2000 - Magnetek HPV 900 AC Vector Drive
– Drive A1).
4. Ride the car up and down, staying away from the terminal floors. Observe the ride.
There should be no vibration at any point. If vibration is present, try adjusting the
RESPONSE parameter under ADJUST A0, DRIVE A1 to a slightly lower value.
Make any final changes to the motion parameters to obtain the desired ride.
5.
Remove all weights from the car. Staying away from the terminal floors, make one, two
6.
and multi-floor runs up and down.
Add weight to the car, approximately 100 pounds at a time. Staying away from the
7.
terminal floors, observe one, two, and multi floor runs to be sure that the car rides well
under all load conditions. Keep adding weight until the car has full load, less the weight
of anyone riding the car.
Remove all jumpers from the Limit board and re-install all connectors.
8.
9. Go to Section 8 of this manual and perform a learn procedure for the Limit board.

7b.6 Drive Reference Information

7b.6.1 Using the Programmer

The hand held programmer comes standard on the HPV 900 drive. It is used to program the
drive and display data from the drive to facilitate tuning and troubleshooting.
There are three menu levels in the drive. They are the Menu level, the Sub-menu level, and
the Entry level. There are five keys on the front of the programmer. These keys perform
different function, depending at what menu level the programmer is at.
When the programmer is at the Main Menu level, the left and right arrows move the
programmer between the Main Menu selections. The up and down keys move the programmer
into the various Sub-Menus at each Main Menu selection. Pressing the "Enter" key will move
the programmer into the Sub-Menu currently displayed on the programmer.
When the programmer is at the Sub-Menu level the up and down arrows display various
parameters in the Sub-Menu. Pressing the "Escape" key will move the programmer back to the
Main Menu level. Pressing the "Enter" key while at the Sub-Menu level moves the programmer
into the Entry level to modify the displayed parameter.
At the Entry level, the left and right arrows move a cursor to highlight data. When a digit is
highlighted, pressing the up arrow will increase the value, and pressing the down arrow will
decrease it. Pressing the "Enter" key will save the value displayed on the programmer.
Pressing the "Escape" key will move the programmer back to the Sub-Menu level.
Revision: AA 2.2 Printed 03- 15 - 03 7b - 6