Door Parameters - O. Thompson Microflite Ultra 2000 Installation & Adjustment Manual

11.7.4 Door Parameters Menu
DOOR TIME (0.1 SEC)
DOOR TIME - CAR CALL - is the door open dwell time when answering a car call only. If the
electric eye is broken, the door time is reduced to the parameter value, DOOR REOPEN TIME.
DOOR TIME - HALL CALL - is the door open dwell time when answering a hall call. If the electric
eye is broken or the safety edge or the door open button is triggered, the door time is the
remaining door open time or the DOOR REOPEN TIME, whichever is greater.
DOOR TIME - NUDGING - is the door open dwell time that will trigger door nudging. Time starts
when doors start to open.
DOOR TIME - FREIGHT - is the door open dwell time after the Freight Door Time input is
activated and shut off. This feature will only work if the FDT input is present or if FDTF or FDTR
(front and rear) are present.
DOOR TIME - REOPEN - is the time the doors will remain open after SE, EE, or DOB operate.
DOOR TIME - RECYCLE - is the time the lock and gate contacts have to make. If they do not
make within this time, the doors will reopen. The timing starts when close cycle is initiated.
DOOR TIME - LOBBY - this time applies to a car at the lobby floor that is NOT designated as this
car up (TCU).
DOOR TIME - LOBBY AFTER CALL- this time applies to a car, at the lobby floor, that is NOT
designated this car up (TCU) and it is the time the door will stay open, in the lobby, after a car call
is entered or a hall call assignment is registered.
SE/EE/DOB CHANGES DOOR TIME TO REOPEN TIME FOR CAR CALLS? Y/N - If set to "Yes"
the door time will be reduced to the time entered into the DOOR TIME - REOPEN parameter when
the SE, EE or DOB inputs are activated.
CLOSE BUTTON FUNCTIONAL IN LOBBY Y/N - Enables or disables the door close button when
the car is in the lobby.
DOOR RECYCLE ON DIRECTION CHANGE? - Refers to double direction hall calls on the floor, at
which the car is standing. "Yes" will allow a full door cycle before the car will change direction. No, will
allow the car to switch direction, after the door dwell time expires.
DOORS OPEN SIMULTANEOUSLY ON AUTO? Y/N - Applies to double door cars on Automatic
Service only. Both doors will open simultaneously and, if both calls are present, both calls will be
unlatched. This parameter must be set to the same value on the dispatcher as well. This
parameter must be set to "No" on single or non-selective door cars.
DOOR CLOSE MOTOR PROTECTION? Y/N- Automatic interruption of door recycling in case of
door close / door gate failure takes place if parameter is set to "Yes" otherwise the door is recycled
till DCL and / or DG make. This is typically set to "Yes".
Revision AA 2.2
Microflite Ultra 2000
CAR CALL 000
NUDGING 0000
REOPEN 000
LOBBY 000
Printed 03 - 15 - 03
HALL CALL
FREIGHT
RECYCLE
LOBBY AFTER CALL 000
000
000
000
11 - 19