9.3
K-Tech LW4200
Preparation
9.3.1
Before beginning the installation of the unit, the car should be adjusted and running at contract
speed. The cab should be complete, with all walls, ceiling panels, and flooring installed. If not,
do not install the unit until the cab is complete!
9.1.2
Sensor Mounting
The sensor must be mounted while the car is empty and at the lowest landing. Failure to do so
could cause the sensor to 'unload' at lower floors and lead to erratic operation.
Referring to the figure below, locate the area of the crosshead where the sensor will be
mounted. This area should be clear of brackets or other structural members.
File, or sand the area where the sensor will be located to remove any paint or unevenness.
Included in the box with the sensor is a drill template. The template will properly locate the
holes for the sensor. Lay the template on the cleaned area of the crosshead with the bend
Revision: AA 2.2
Microflite Ultra 2000
Printed 03 - 15 - 03
9 - 6