Table of Contents
Advertisement
Check over entire unit carefully before first operation. Tighten bolts, set screws, and chains which
may have come loose in handing. Lubricate as explained in the Lubrication Guide. Successful operation will
be achieved by periodic adjustments and experience of the operator. Make sure to read and
understand all adjustments.
TRACTION CONNECTIONS
PTO Drive
Attach the Forage Box PTO to the tractor PTO shaft locking it into position. Maintain correct distance
between the tractor drawbar hitch, tractor PTO and the universal joint at front of unit. This is necessary
to prevent overextending the universal joint shaft.
1. Maintain a straight alignment between the Forage Box and the tractor.
2. Maintain a distance of 6"- 12" between the top of the tractor drawbar and the center of the tractor PTO.
An 8" distance is standard.
After the correct distance is obtained, depress the locking collar against the spring tension, and slide the
yoke onto the tractor PTO shaft. Release the locking collar and move the yoke ahead or back until the
lock engages into the groove on the shaft.
NOTE: Do NOT attempt to use a hammer to help in attaching the PTO drive connection.
The tractor drawbar should be adjusted in relation to the tractor PTO shaft as follows:
1. Hitch point of drawbar 14 inches behind tractor PTO shaft.
2. Hitch point of drawbar at least 8 inches, but not more than 14 inches below PTO shaft.
3. Hitch point of drawbar at least 13 inches, but not more than 22 inches above ground level.
4. When unloading, keep the hitch point of the drawbar and PTO shaft in a straight line to the Forage Box.
If the PTO is at an angle, it will result in a pounding noise and damage to U joints and the safety clutch.
IMPORANT! DO NOT operate unless 2" minimum extension is maintained.
The telescoping PTO drive is designed to rotate freely inside the drive shield tubes.
mechanism for several minutes. This will serve as a break-in and as a check that all parts are
assembled and lubricated properly.
After you have run the Forage Box for several minutes, check the main apron chains again for proper
adjustment, as paint may initially come off the apron chains and chains may loosen. The main apron
chains must be taken up evenly before you use the forage box. Check again after the first few loads. The
main aprons should be at proper tension at all times. See Adjustment Section for details.
The Power Take Off Shaft from tractor to box should not
be connected for road travel or field operation. Damage
may result to the PTO Shaft. A convenient hanger
is provided to hold PTO shaft during the time it is not being
used to unload.
PREPARING FOR OPERATION
(Shields are
removed
for viewing)
-14-
Run the unloading
Advertisement
Table of Contents
