Displaying Transceiver Module Information; Rebooting The Device - H3C SecPathT5030 Installation Manual

To view the diag.gz file:
a. Execute the
decompress the file.
b. Execute the
c. Execute the
d. Press Page Up and Page Down.
•
Display the operational statistics for each functional module of the device:
<Sysname> display diagnostic-information
Save or display diagnostic information (Y=save, N=display)? [Y/N]:n
===============================================
===============display clock===============
11:03:38 UTC Sat 01/13/2018
=================================================
...

Displaying transceiver module information

Identifying transceiver modules
To identify transceiver modules, you can use the following command to view the key parameters of
the transceiver modules. The key parameters include transceiver module type, connector type,
central wavelength of the laser, transmission distance, and vendor name.
To display transceiver module information, execute the
[
interface-type interface-number
Troubleshooting transceiver modules
The system outputs alarm information for you to locate and troubleshoot faults of transceiver
modules.
To display the alarm information about transceiver modules, execute the
alarm interface

Rebooting the device

CAUTION:
• If the main system software image file does not exist, do not use the
the device. Specify the main system software image file first, and then reboot the device.
• The precision of the rebooting timer is 1 minute. 1 minute before the rebooting time, the device
prompts "REBOOT IN ONE MINUTE" and reboots in one minute.
• If you are performing file operations when the device is to be rebooted, the system does not
execute the
To reboot the device, use one of the following methods:
•
Use the
•
Schedule a reboot to occur at a specific time or date or after a delay by using the
reboot
•
Power cycle the device. This method cuts off the power of the device forcibly, which might
cause data loss or hardware damage. It is the least-preferred method.
tar extract archive-file diag.tar.gz
gunzip diag.gz
diag command.
more
[
interface-type interface-number
command for security.
reboot
command to reboot the device immediately.
reboot
command.
command.
display transceiver interface
] command.
34
command in user view to
display transceiver
] command.
command to reboot
reboot
schedule