Reversing The Door Swing - Matsui MUF1858W Instruction Book

6
NOTES
Re versing the door swi ng
Ensure the Freezer is unplugged and
empty.
Adjust the two levelling feet to their highest
position.
We recommend you have someone to assist
you.
Tools required
Phillips style screwdriver
Flat bladed screwdriver
3
Slide the Freezer door down about 15cm [6"]
and off the top hinge pin and lift away from the
Freezer.
6
Slide the Freezer door back on to the top
hinge, making sure it's the right way up.
Screw the bottom hinge into place on the new
side.
Note: to take the door off it is necessary to tilt the
Freezer backward. You should rest the Freezer
on something solid and place something under the
rollers so that it will not slip during the door change
process.
DO NOT lay the Freezer completely flat as this
may damage the coolant system.
4
Using the flat bladed screw driver remove the
pin from the top bracket. Replace it in the hinge
bracket on the opposite side.
7
Check that door is
aligned
horizontally and
vertically and that the
seals are closed on all
sides before finally
tightening the bottom
hinge.
Re-adjust the levelling
feet.
1
Undo the three screws in each bracket using the
Phillips screwdriver.
5
Remove the screw from the side of the Freezer
where the bracket is to be re-fitted and replace
on the other side.
2
Remove the screws and bracket. Place to one
side.