Reversing The Door Swing - Matsui MTT667WS Instruction Book

Reversing The Door Swing

• Ensure the Appliance is unplugged and empty.
• Adjust the two levelling feet to their highest position.
• We recommend you have someone to assist you.
Tools required
• Phillips style screwdriver
• Flat bladed screwdriver
2
Unscrew the three screws from the bottom bracket. Remove the
foot from opposite side.
5
Remove the two screws from top bracket and replace on the other
side. You will need to first remove the plastic caps from the other side.
NOTE:
To take the door off it is necessary to tilt the Appliance
backward. You should rest the Appliance on something solid
e.g. a chair just below the top panel.
DO NOT lay the Appliance completely flat as this may
damage the coolant system.
3
Place to one side.
6
Slide the Appliance door back on to the Top hinge, making
sure it's the right way up.
Screw the bottom hinge into place on the new side. Replace the
other foot on the other side. Replace the plastic covering by
clicking back into position on the door hinge.
1
Remove the plastic covering from the bottom door hinge.
4
Slide the Appliance door down about 15cm [6"] and off the
Top hinge pin and lift away from the Appliance.
Check that the door is aligned
7
horizontally and vertically and
that the seals are closed on all
sides before finally tightening
the bottom hinge.
Re-adjust the levelling feet.
5