Introducing Your Ne W Freezer - Matsui MUF1858W Instruction Book

2

Introducing Your Ne w Freezer

Before use
Please read these instructions carefully before using your new Matsui Freezer.
The Freezer is for indoor, domestic use only.
Introducing Your Ne w Freezer
Location
When selecting a position for your Freezer you should make sure the floor is flat and firm,
and the room is well ventilated with an average room temperature of between 16°C and
32°C. Avoid locating your Freezer near a heat source, eg. cooker, boiler or radiator. Also
avoid direct sunlight in lean-to's or sun lounges. If you are placing your Freezer in an out-
building such as a garage or annex ensure that the Freezer is placed above the damp course,
otherwise condensation will occur on the Freezer cabinet. Never place the Freezer in a wall
recess or into fitted cabinets or furniture.
When your appliance is working, the condenser at the back (exposed models) may become
hot or alternatively the sides may become hot (hidden condenser models )
Moving the Freezer
Your Freezer has two wheels at the rear. The easiest way to move the Freezer is to tip it
backwards just far enough to lift the front feet off the ground and roll it into position.
Levelling the Freezer
Unscrew the packaging support from the base of the Freezer and
replace with the 2 Levelling Feet. Make sure the Freezer is level. Use
the Levelling Feet at the front. If the Freezer is not level, the doors
and magnetic seal alignments will be affected.
Cleaning before use
Wipe the inside of the Freezer with a weak solution of bicarbonate soda. Then rinse with
warm water using a 'wrung-out' sponge or cloth. Wash the baskets and shelves in warm
soapy water and dry completely before replacing in the Freezer. The external parts of the
Freezer can be cleaned with wax polish. If you require more information refer to Cleaning on
page 6.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the Freezer. If
not, please consult a qualified person to correct.
Before switching on!
DO NOT SWITCH ON UNTIL TWO HOURS AFTER MOVING THE FREEZER.
The coolant fluid needs time to settle.