Download
Share
Print this page
D-CUT GC-230 Operation Manual
  1. Manuals
  2. Brands
  3. D-CUT Manuals
  4. Cutter
  5. GC-230
  6. Operation manual

D-CUT GC-230 Operation Manual

Manual trim cutter
Hide thumbs
1
2
3
4
5

Advertisement

Quick Links

Download this manual
OPERATION MANUAL
Manual Trim Cutter GC-230
www.dcutproducts.com
CUTTING AND C

Advertisement

loading

Related Manuals for D-CUT GC-230

Summary of Contents for D-CUT GC-230

  • Page 1 OPERATION MANUAL Manual Trim Cutter GC-230 www.dcutproducts.com CUTTING AND C...
  • Page 2 Handle Assembly Insert the handle to the handle base and use the provided screw / washer / spring washer as shown. Straight Cut Insert the floor plank between the cutting blade and the base, flush with the guide bar on the working table and hold the plank then pull handle down to complete a cut.
  • Page 3 Changing the Nylon Bar Use the provided Allan wrench to remove the four screws, and then remove the old nylon bar. Warning: Do not put your fingers against the sharp edge of the blade at any time. Transport Push down the handle and then move the lock-pin to lock the blade hold in a close position as shown for the safety.

  • Page 4: Explosive View

    Explosive View...
  • Page 5 Explosive View Parts Q’ty Parts Q’ty Screw M5 × 16 Right ABS Handle Spring Washer φ5 Nut M4 Washer Screw M4 × 31 Nylon Bar Holder Base Left ABS Handle Nylon Bar Holder Screw M5 × 8 Nylon Bar Working Table A Right Bracket Working Table B Nut M8...