Table of Contents
Advertisement
PRESYS
⏐ Instruments
2.4 - Output Signal Connection
In their most complete versions (dual loop) the Stations can be provided with up
to two output signals: output 1 and output 2. Output 1 is used both in the dual loop and
single loop Stations. Output 2 is used only in the dual loop instrument depending on the
Station software configuration established by the user.
Outputs 1 and 2 provide three different types of analogic signal at the I/O
terminals: current (4 to 20mA), voltage (0 to 5VDC) and voltage (0 to 10VDC).
Note that the I/O terminals will only show output signals if the corresponding
optional module is installed and the output is correctly configured. Refer to sections 3.2
on Configuration and 4.3 on Optional Module Connection for further details on
installation and configuration of optional modules.
Fig. 6 - Output Connections
DCY-2058 and DCY-2059
Installation
Page 8
Advertisement
Table of Contents
