Bolt (5/16-18 X 1/4 Inch); Washer; Flange Nut (3/8-16 Inch); Bolt (3/8-16 X 1 Inch) - Toro 41621 Operator's Manual

Figure 22

1. Flange nut (3/8-16 inch)

2. Washer (7/16 inch)
6. Install the washer and spring pin to the underside
of the hose-reel frame
Figure 23

1. Washer

7. Connect the remaining wiring harness plugs
to the motor, the main harness power, and the
hose reel kit plugs.
g023425

3. Bolt (3/8-16 x 1 inch)

(Figure 23).
g028034
2. Spring pin
6
Installing the Control Valve
for the Hose Reel
Parts needed for this procedure:
1 Control valve
1 T-fitting
1 Hose clamp
3 Cable tie
1 R-clamp
1 Hose (71 inches)
1 Clamp
1 90° elbow
1 Tube coupler
1 Nut (1/4-20 inch)
1 Flange nut (3/8-16 inch)
1 Pressure transducer tube
1 Bolt (1/4-20 x 3/4 inch)
1 Valve mount
1 Control-valve bracket
4 Bolt (6 x 12 mm)
4 Washer (8 mm)
4 Flange head bolt (6 x 16 mm)
4 Flange locknut (6 mm)
12