Table of Contents
Advertisement
Figure 16
1. Hold-down bracket
2. Flange locknut (3/8 inch)
3. Bolt (3/8 x 1-1/2 inches)
2.
Align the slot in the hold-down bracket with the
hole in the valve mount
3.
Loosely assemble the hold down to the valve
mount
(Figure
16) with a bolt (3/8 x 1-1/2
inches), 2 washers (3/8 inch), and a flange
locknut (3/8 inch) that you removed in
the Rinse Tank (page
4.
Repeat steps
1
through
at the other recess in the rinse tank
5.
Carefully tighten the bolts and flange nuts by
hand.
Important:
The rinse tank must be seated
and secure, but the hold down should not
deform or warp the tank
Note:
Once the rinse tank has been initially
filled, check the hold downs and the rinse tank
for play (the weight of the water in the tank
can further seat the tank against the frame). If
needed, tighten the bolt(s) and flange locknut(s)
until the hold downs are snug against the rinse
tank—do not deform the tank.
Installing the Spray Tank Suction
Hose
1.
Insert the 90° barbed fitting of the suction hose
to the housing for the suction screen until the
fitting is fully seated
4. Washer (3/8 inch)
5. Valve mount
(Figure
16).
Removing
5).
3
for the other hold down
(Figure
(Figure
17).
1. Retainer fork
2. 90° barbed fitting (supply
hose)
g244762
2.
Secure the 90° barbed fitting to the housing for
the suction screen with the retainer fork
17).
Assembling the Supply Hose
1.
Align the 90° barbed fitting of the supply hose
with the housing for the suction screen
18).
16).
1. 90° barbed fitting (supply
hose)
2. Housing (suction screen)
2.
Secure the 90° barbed fitting to the housing
(Figure
18) with the retainer fork that you
removed in step
(page
5).
10
Figure 17
3. Housing (suction screen)
Figure 18
3. Retaining fork
1
of
Removing the Rinse Tank
g244761
(Figure
(Figure
g206490
Advertisement
Table of Contents
