Table of Contents
Advertisement
1
Preparing the Machine
No Parts Required
Procedure
WARNING
Battery terminals or metal tools could short
against metal machine components, causing
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the tractor.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
WARNING
Incorrect battery cable routing could damage
the machine and cables, causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
1.
If the optional rinse tank is installed, empty the
tank into the spray tank; refer to Operating the
Rinse Kit in the Installation Instruction for the
Tank Rinse Kit.
2.
Ensure that the sprayer tank of the machine is
empty of all fluids.
Note:
If the sprayer tank has contained
chemical solutions, flush the tank and sprayer
system thoroughly with clean water; refer to your
vehicle Operator's Manual for instructions.
3.
Park the machine on a level surface, set the
parking brake, shut off the sprayer pump, shut
off the engine, and remove the key from the key
switch.
4.
Disconnect the negative battery cable from
the negative post of the battery; refer to the
Operator's Manual.
5.
Disconnect the positive battery cable from
the positive post of the battery; refer to the
Operator's Manual.
2
Removing the Rinse Tank
and Moving the Spray Tank
Multi Pro 5800 Turf Sprayers
with the Optional Rinse-Tank Kit
Installed
No Parts Required
Removing the Rinse Tank
1.
At the top of the spray tank, remove the retainer
fork that secures the 90° barbed fitting of the
suction hose to the housing for the suction
screen, and separate the barbed fitting from the
housing
(Figure
1. 90° barbed fitting (supply
hose)
2. Housing (suction screen)
2.
Remove the 90° fitting from the suction-screen
housing
(Figure
3.
At the bottom of the rinse tank, remove the
retainer fork that secures the 90° fitting of the
supply hose to the bulkhead fitting
5
2).
Figure 2
3. Retainer fork
2).
(Figure
g206490
3).
Advertisement
Table of Contents
