Toro 41621 Operator's Manual page 18

7
Connecting the Spray Hose
Parts needed for this procedure:
1 Spray-gun hose with fitting
1 Spray gun
1 Small hose clamp
Procedure
1. Apply PTFE sealant to the threads of the hose
fitting on the long hose, and install the fitting into
the connecting tube on the reel
Figure 40
2. Connect the free end of the long hose to the
fitting on the spray gun
Figure 41
1. Hose
2. Hose clamp
3. Secure the end of the hose with a small hose
clamp.
(Figure 40).
g001719
(Figure 41).
g017765
3. Barb
4. Spray gun
4. Connect the battery cables as follows:
WARNING
Incorrect battery cable routing could
damage the machine and cables, causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
A. Connect the positive battery cable to the
positive post of the battery; refer to the
Operator's Manual.
B. Connect the negative battery cable to the
negative post of the battery; refer to the
Operator's Manual.
5. Press the hose wind button, and carefully guide
the hose onto the reel moving the hose from
side to side to evenly distribute the hose.
CAUTION
Hands, loose clothing, long hair, and
loose jewelry could get caught in the
hose and reel while rewinding and cause
injury.
• Keep your hands clear of the reel and
hose while it is rewinding.
• Do not wear loose clothing or loose
jewelry and tie up long hair.
18