Toro 41621 Operator's Manual page 15

Drilling the Manifold Mount
Multi Pro 5800 Turf Sprayers—2016 and After
1. Align the flange of the T-fitting with the flange
of the 90° fitting with a connector for the sense
tube (Figure 31).
Figure 31
1. Flange (T-fitting)
2. Flange clamp
3. Gasket
4. 90° fitting (with a connector
for the sense tube)
2. Loosely assemble the T-fitting and the 90° fitting
with a gasket and a flange clamp
Note:
Rotate the control-valve bracket as
necessary to align it flush with the surface of the
valve mount.
3. Using the control-valve bracket as a template,
mark the location of the holes in the bracket onto
the surface of the manifold mount
g033916
5. 90° fitting (section-valve
bypass)
6. Hose clamp
7. Hose (section-valve
bypass)
(Figure 31)
(Figure 32).
4. Remove the clamp, gasket, T-fitting with the
flange from the 90° fitting with a connector for
the sense tube
5. Center punch the marks on the manifold mount
that you made in step 3.
6. Drill 4 holes 6 mm (1/4 inch) into the manifold
mount at the centerpunch marks that you made
in step 5.
1. Drill and drill bit—6 mm
(1/4 inch)
15
Figure 32
(Figure 31).
Figure 33
2. Manifold mount
g033918
g033919