Sleeping Mode; Low Voltage Alarming; Installation - netvox R718IJK User Manual

Wireless multi-sensor interface for 0-24v adc, dry contact and 4-20ma sensors

Hide thumbs Also See for R718IJK:

Table of Contents

6. Sleeping Mode

R718IJK is designed to enter sleeping mode for power-saving in some situations:

(A) While the device is in the network → the sleeping period is Min Interval.

(During this period, if the reportchange is larger than setting value, it will wake up and

send a data report).

(B) When it is not in the network → R718IJK will enter sleeping mode and wake up every 15

seconds to search a network to join in the first two minutes. After two minutes, it will wake

up every 15 minutes to request to join the network.

If it's at (B) status, to prevent this unwanted power consumption, we recommend that users

remove the batteries to power off the device.

The operating voltage threshold is 3.2V. If the battery voltage is lower than 3.2V, R718IJK will

send a low-power warning to the LoRa network.

When using it, the back of it can be adsorbed on the iron surface, or the two ends can be fixed to the

wall with screws.

Note: To install the battery, use a screwdriver or similar tool to assist in opening the battery cover.

Table of Contents