Prestart Inspection Checklist - Upright SB47JRT Operator's Manual

Prestart Inspection Checklist

Item
Operator's Manual
Engine
Oil level
Coolant
Radiator
Air cooled engines
Fuel tank and line
Air filter
Charging system
Cold weather start kit
Electrical System
Emergency power battery
Battery fluid level and terminals
Cables and wiring harness
Hydraulic System
Fluid level
Fluid filter
Hoses, tubes, and fittings
Cold weather warm-up kit
Tires and Wheels
Foam filled
Lower Control Station
Operating controls
Emergency stop and emergency power
Emergency Lowering
Level Sensor
Flashing Light
Sandblast Protection Kit
Structures
Weldments
Slide pads
Fasteners
Wire ropes
Upper Control Station
Guardrail system and lanyard anchors
Operating controls
Emergency stop and emergency power
Horn
Electrical power outlet
Drive motion alarm
Driving and work lights
Platform control cover
Tow Kit
Placards and Decals
SB47JRT – 0075522
Inspect For
In manual holder
Between full and add marks
Liquid cooled engines – proper fluid level
Cap tight, good condition and clean
Air intake and fan free of obstructions. Belt
in good condition
Tank full, cap in place and tight/no leaks
Clear indicator
Proper operation
No damage or deformation
Condition and charged for proper operation
Proper level/clean, connectors tight
No wear or physical damage
Between full and add marks
Verify operation in the green zone
No leaks
Proper operation
Good condition
Proper operation
Shuts off lower controls/proper operation
Proper operation
Sounds tilt alarm
Proper operation
In place and proper operation
Welds intact, no damage or deformation
In place, no damage or deformation
In place and tight
No deformation or broken strands
Welds intact, no damage or deformation
Proper operation
Shuts off upper controls/proper operation
Sounds when activated
Proper operation of outlet and GFCI
Sounds when aerial platform moves
Proper operation
In place and proper operation
In place, no damage or deformation
In place and readable
Chapter 7 – Prestart Inspection
Ok
37