PROPANE HEATERS
1. Open the tank's cover.
2. Assemble bushing, pigtail connector and regulator as
shown. Tighten connections securely. See Fig. 2.
3. Form the connector to ensure the regulator will be
supported by the tank, and the tank valve cover will
protect the regulator from weather conditions.
FIG. 2
3/4x 1/4 BUSHING
CONNECTING REGULATOR TO GAS SUPPLY
4. Thread connector's POL fitting counter-clockwise into
5. Open the tank valve.
6. Check all connections with an approved leak detector.
7. When storing or transporting the heater, ensure the
NATURAL GAS HEATERS
---
POL
----
PIGTAIL CONNECTOR
the tank valve. Tighten securely. See Fig. 2.
Close the tank's cover.
connector's fitting is protected from damage and dirt
entry.
The regulator only should be used if the supply
pressure to the heater is above the maximum inlet
pressure stated on the heater's dataplate.
Connect the regulator to the natural gas supply line.
Gas supply pressure to the regulator must be a
minimum of 13.7 kPa.
9