Connecting To An Ac Power Source - Cisco XR 12406 Installation Manual

Chapter 3 Installing the Cisco XR 12406 Router
Table 3-6
Router Power
AC power
DC power
Refer to
AC PDU.
When operating your router on a single power module, the second power module
Note
bay must have a blank filler (MAS-GSR-PWRBLANK=) installed to ensure EMI
compliance.
Attach an ESD-preventive strap to your wrist and connect the leash to the chassis
Step 1
or to another grounded, bare metal surface.
Locate the two AC power cords and remove them from their shipping packaging.
Step 2
Verify that the AC power cords shipped with the power supplies are the correct
type for your site.
Note
OL-13831-01
Required Power Combinations
Combination
1 AC-input power supply
1 power supply blank
2 AC-input power supplies
1 DC-input PEM
1 PEM blank
2 DC-input PEMs
Figure 3-18 and use the following procedure to connect AC power to the
If you have received the wrong type of AC power cord, contact your
service representative for a replacement.

Connecting to an AC Power Source

Cisco XR 12406 Router Installation Guide
3-27