Tools and Equipment
Tools and Equipment
Safety Recommendations
Repacking the Router
Cisco XR 12406 Router Installation Guide
B-4
You will need the following tools and equipment to repack the router for shipping:
Router packaging kit
•
ESD-preventive wrist strap
•
Number 1 and Number 2 Phillips screwdrivers
•
9/16-inch wrench
•
10-mm wrench (either open-end or socket)
•
•
Plastic carton straps and strap installation tools
Before you begin the router repacking procedures, review the following safety
information:
The safety recommendations listed in the
•
on page 2-2
of this guide.
The safety warnings listed in the Cisco publication Regulatory Compliance
•
and Safety Information for the Cisco XR 12000 Series Router (Document
Number 78-4347-19) that accompanied your router.
Repacking the Cisco XR 12406 router into the shipping container is presented in
the following procedure. This procedure assumes you have repacked the
accessory kit and have the anchor clips and angle brackets, bolts, screws, and
carton that were removed when the chassis was unpacked.
There are three phases in the repacking process:
Securing the router to the pallet base
1.
Reassembling the protective packaging around the router on the pallet base
2.
(see
Figure
B-1).
Strapping the entire package to the pallet base
3.
Appendix B
Repacking the Router
"Safety and Compliance" section
(Figure
B-2).
(Figure
B-3).
OL-13831-01