Removing and Replacing Field-Replaceable Units
Front Cover Procedures
The original Cisco 10008 router is equipped with a plastic front cover that ensures proper air flow
through the system and protects the cables and connectors from damage. The following procedures
describe how to remove and replace the front cover.
Your router may not have a front cover. Only the original Cisco 10008 chassis was equipped with a
Note
plastic front cover. Later redesigned models do not use a front cover.
Removing the Front Cover
Use the following procedure to remove the front cover from the chassis:
Figure 5-1
Unlock a bezel plug by wedging the tip of a flat-blade screwdriver between the top and bottom sections
Step 1
of the plug, and then rotating the screwdriver to loosen the top portion of the plug
Repeat this procedure for all four bezel plugs, and then remove the plugs.
Cisco 10008 Router Hardware Installation Guide
5-4
Unlocking the Bezel Plugs
FANS OK
FAN FAILURE
MULTI-FAN FAILURE
Cisco 10000
POWER
FAULT
MISWIRE
POWER
POWER
FAULT
FAULT
MISWIRE
MISWIRE
Chapter 5
Maintaining the Cisco 10008 Router
FANS OK
FAN FAILURE
MULTI-FAN FAILURE
POWER
FAULT
MISWIRE
POWER
POWER
FAULT
FAULT
MISWIRE
MISWIRE
(Figure
Cisco 10000
5-1).
OL-0659-13