Christie CP2000-M Instruction Sheet page 5

8. Using a #3 Phillips
screws are located along the front edge of the ballast, another in the back-left corner and the front-
right corner. NOTE: To access the screws on the left-side close the lamp door.
9. Pull the ballast out of the projector housing.
10. When installing a new ballast, repeat instructions in reverse. Follow the instructions provided for
replacing the lamp.
CP2000-M/MR Ballast Replacement Instruction Sheet
020-100511-01 Rev. 1 (05-2010)
, remove the five captive screws securing the ballast to the housing. Three
™
Figure 7 Remove Ballast
5 of 5