Christie CP2000-M Instruction Sheet page 4

b. Using a #2 Phillips
4) and one on the bottom near the lamp adjuster assembly (not shown).
c. Carefully, lift the blower out of the projector housing.
6. Disconnect the AC power harness by pushing in on the clip. (Figure 5)
7. Disconnect the Ballast Communication harness by removing the two retaining screws and pulling
up (Figure 6).
4 of 5
screwdriver, loosen the two captive screws on the top of the unit (Figure
™
Figure 4 Remove Lamp Blower
Figure 5 AC Power Harness
Figure 6 Ballast Communication Harness
CP2000-M/MR Ballast Replacement Instruction Sheet
020-100511-01 Rev. 1 (05-2010)