Steering Stop Components; Installation - Mercury FourStroke 2.5 Service Manual

Clamp/Swivel Bracket and Driveshaft Housing

Steering Stop Components

a
e

Installation

1. Lubricate the driveshaft housing between the upper and lower flanges with 2‑4‑C with PTFE.
2. Install the thrust plate and split plastic bushing onto the driveshaft housing.
NOTE: Install the split plastic bushing with the split facing towards the front of the engine.
3. Lubricate the thrust plate and plastic bushing with 2‑4‑C with PTFE.
f
e
d
Tube Ref No.
2-4-C with PTFE
95
4. Align the tab on the rubber bushing with the pocket of the swivel bracket. Install the rubber bushing onto the swivel bracket.
NOTE: It is not necessary to use adhesive to attach the rubber bushing onto the front swivel bracket.
Page 5A-14
c
b
d
a
b
c
Description
Driveshaft housing between flanges, swivel bracket thrust
b
d
26145
a - Thrust plate
b - Plastic bushing
c - Split in plastic bushing
d - Lower flange
e - Driveshaft housing
f - Upper flange
26155
Where Used
plate, and plastic bushing
a - Stopper and pin
b - Steering stop lever
c - Bolt and washer
d - Spring ends
e - Swivel bracket
Part No.
92-802859A 1
90-8M0065421 NOVEMBER 2012