Turning On the Monitor
To turn on the monitor:
1. Press the ON key.
When turned on, the monitor does the following:
•
The pulse strength bar graph segments light one at a time.
•
The monitor's software revision is momentarily displayed.
•
The patient number is momentarily displayed.
•
The monitor is in Clinician Mode.
2. After a few seconds the % SpO
bar graph should be shown. If not, see the Troubleshooting section
for help.
Oximeter Clinician's Operation Manual
Chapter 4: Operating Instructions
Patient's SpO2 Shown Here
Patient's Pulse Rate Shown Here
Patient's Pulse Strength Shown Here
Figure 4-7: SpO2, Pulse Rate,
and Pulse Strength Bar Graph
value, pulse rate, and pulse strength
2
4-11