Sentry Sample Sequencer 5 Installation, Operation And Maintenance Manual page 39

5.2.27 Units
To set the units to be displayed for each sequence, use the Units Screen.
Figure 33: Units Screen
The units for the active sequences are displayed on this screen. Units "x" corresponds to the
units for sequence "x."
To update the units for an analyzer:
12. Touch the unit area you wish to update.
13. Use the keypad that appears to enter the unit name.
14. When you have completed the unit name, touch the enter button in the lower right hand
corner. This will enter the unit name you have created on the Units Screen.
15. Repeat this process for each unit name you would like to change.
16. When finished, touch the save button to save all unit names, or touch the escape button to
return to the previous screen without saving.
SPD 5.5.15
Sentry Equipment Corp | Sample Sequencer

5
33