Sentry Sample Sequencer 5 Installation, Operation And Maintenance Manual page 37

can be sequenced. Each sequence is limited to a total of 16 sequence points. At the end of the
sequence, the sequence will wrap to the first point. Not all 16 points need to be filled. When
finished, touch the save button to save all sequence values, or touch the escape button to
return to the previous screen without saving.
5.2.25 Sample Names
To name each sample line, use the Sample Names Screen. The factory default for each sample
point description is in the form of "SAMPLE x NAME."
Figure 30: Sample Names Screen
To name a sample line:
1. Select the sample line you wish to update by touching the corresponding sample name
area.
2. An alphanumeric keypad will appear where the sample name can be entered.
3. When you have completed the sample name, touch the enter button in the lower right hand
corner. This will enter the sample name you have created on the Sample Names Screen.
4. Repeat the above process for any sample name you would like to change.
5. When finished, touch the save button to save all sample line names, or touch the escape
button to return to the previous screen without saving.
SPD 5.5.15
Sentry Equipment Corp | Sample Sequencer

5
31