Section 9: Multiple Input/Output Modules; Description; 1: Fdm-1; 2: Fdrm-1 - Honeywell Notifier AFP-100 Wiring Manual

Intelligent control panel slc

Table of Contents

9.1 Description

9.1.1 FDM-1

The FDM-1 is similar to the FMM-1, except intended for use in intelligent two-wire systems providing two independent Style B (Class

B) IDCs at two separate, consecutive addresses. Addresses can start using either an even or odd number.

9.1.2 FDRM-1

The FDRM-1 is an addressable module that functions as two individual relay control modules (two isolated sets of Form-C relay con-

tacts) and two Class B monitor modules.

Ratings for the dry relay contacts on a Form-C module are:

Load Description

Inductive (PF = 0.35)

Resistive

Inductive (L/R = 20ms)

Inductive (PF = 0.35)

Resistive

Inductive (PF = 0.75)

Inductive (PF = 0.35)

For more information on the module specifications refer to the installation instructions provided with this device.

9.2 Setting the SLC Address

Each multiple input/output module is factory preset with an address of "00". To set an SLC address, use a screwdriver to adjust the rotary

switches on the module to the desired address.

9.2.1 FDM-1

Each FDM-1 module can use up to two (2) addresses. The base address selected via the rotary address switches will be assigned to the

first monitored input. The next consecutive address will be assigned to the second monitored input.

9.2.2 FDRM-1

Each FDRM-1 module can use up to four (4) addresses. The base address selected via the rotary address switches will be assigned to

relay output #1 from 00 to 156. The module will automatically assign the next three addresses as appropriate to monitored input #1, relay

output #2, and monitored input #2.

9.3 Wiring the Dual Monitor Module

The figure below shows the FDM-1 wired to the control panel.

Notifier SLC Wiring Manual — P/N 51253:U5 12/20/2017