Pepperl+Fuchs ecom Tab-Ex 02 DZ1 WWAN Installation Manual page 9

Replace the backside cover onto the
device. Check the correct position of
the blue frame and the Protection
Corners once more.
Adjust the Torque screwdriver at
0.45Nm. Screw in the 13 Rear Cover
Screws by using the Torque screw-
driver. Use the Torque screwdriver set
to 0.45 Nm to screw in place the 13
backside Cover Screws.
Finally check that all removed parts
have been correctly reassembled by
carrying out a visually check of the
complete device.
If there are any signs of damage or
incorrect assembly of the device
it should be prevented from being
used in the hazardous location. The
instructions given in the Safety Leaflet
document shall be followed.
9