Using The Boost Function; Additional Features - Secure radbot 1 Instruction Manual

Using the Boost function

Additional features

Valve pin maintenance cycle
Over time, radiator valve pins can become
stuck if not used regularly. To keep the
valve functioning correctly, Radbot 1
automatically performs a weekly cycle
(Decalcination) where the valve is opened
fully and then returned to its normal
position.
If you are feeling cold, press the Boost button. The
thermostat will temporarily increase the temperature
to the maximum set point for the duration of 30
minutes. At the end of this cycle, the device will
revert to the previously selected set point.
Pressing the boost rather than adjusting the
temperature dial is the best option for a temporary
increase in heat as Radbot 1 will automatically revert
to a normal temperature without anyone having to
remember to turn the dial back down.
If the room temperature has already achieved the
maximum temperature range supported by Radbot 1,
the Boost function will not be activated.
If you press the boost by accident, you can
cancel it by temporarily turning the temperature
dial down and then resetting to the normal
level you want for the room.
Frost protection
If the dial is positioned to the snowflake, the
device will be in FROST mode.The temperature set
point will be nominally lowered to 6 °C to save
energy, but high enough to prevent frost damage.
If high humidity is detected the temperature set
point may be raised to reduce the risk of conden-
sation.
12