Installing The Batteries; Fitting Radbot - Secure radbot 1 Instruction Manual

4. Installing the batteries

After securing the correct adaptor on the radiator valve, insert the batteries as shown.
Note: If the batteries are properly fitted, the LED should give one long red flash to indicate the device is active.

5. Fitting Radbot 1

After you insert the batteries, it is important NOT to press the boost button or turn the temperature
wheel until the device is installed onto the radiator.
*
Pressing the boost button or turning the temperature wheel prior to installation can move the valve
plunger from its factory set position making it di cult to install Radbot 1. If this happens accidentally,
remove the batteries for ~ 2 minutes, reinsert and wait 60 seconds then restart the process.
*
Using the retaining ring, tighten
1
Radbot 1 on the adaptor, while rotating
the unit to ensure the temperature dial
is facing towards you in a position where
it can be easily read.
Hand tighten the retaining ring ensuring
2
the device is securely fixed on the radiator
valve.
3
The device is now ready for first use.
9