Profile (CSP+ file) settings
To connect the master station and servo amplifier correctly, a profile (CSP+ file) must be set in GX Works2 or GX Works3.
The CSP+ file can be downloaded from the Mitsubishi Electric FA site or the CC-Link Partner Association website.
Parameter setting
Set [Pr. PN13.0-3 Network protocol setting] to "0004h" and switch the network protocol to CC-Link IE Field Network Basic.
If necessary, set the following servo parameters in accordance with the controller settings.
Servo parameter
PN02
If necessary, set the following network parameters in accordance with the controller settings.
Network parameter
NPA01
NPA02
NPA04
NPA08
Name
Communication error - Detection time
Name
IP address setting
IP address
Subnet mask
Host name
2 CC-Link IE Field Network Basic
2.2 Startup
2
85