Table of Contents
Advertisement
Use printer menus
Menu item
Substitute Size
Off
Statement/A5
Letter/A4
11 x 17/A3
All Listed*
Configure MP
Cassette*
Manual
First
Note: An asterisk (*) next to a value indicates the factory default setting.
Media Configuration
Universal Setup
Menu item
Units of Measure
Inches
Millimeters
Portrait Width
3.5–19 inches (8.5*)
88.9–482.6 mm (216*)
Portrait Height
3.5–19 inches (14*)
88.9–482.6 mm (356*)
Feed Direction
Short Edge*
Long Edge
Multiple Universal Sizes
Tray [x]
Multipurpose Feeder
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Set the printer to substitute a specified paper size if the requested size is not
loaded in any paper source.
Notes:
•
Off prompts the user to load the required paper size.
•
All Listed allows all available substitutions.
Determine the behavior of the multipurpose feeder.
Notes:
•
Cassette configures the multipurpose feeder as the automatic paper
source.
•
Manual sets the multipurpose feeder only for manual-feed print jobs.
•
First configures the multipurpose feeder as the primary paper source.
Description
Specify the unit of measurement for the universal paper.
Note: Inches is the U.S. factory default setting. Millimeters is the
international factory default setting.
Set the portrait width of the universal paper.
Set the portrait height of the universal paper.
Set the printer to pick paper from the short edge or long edge
direction.
Note: Long Edge appears only when the longest edge is shorter
than the maximum width supported.
Assign a unique dimension for multiple universal sizes that are loaded
in each paper source.
Note: This setting appears only when enabled in the Device menu.
From the home screen, touch Settings > Device > Maintenance >
Configuration Menu > Tray Configuration > Multiple Universal
Sizes.
200
Advertisement
Table of Contents
