Adjusting The Fax Darkness; Printing A Fax Log; Blocking Junk Faxes; Holding Faxes - Lexmark MX931 User Manual

Fax

Adjusting the fax darkness

Note: Make sure that fax is configured. For more information, see the
1
Load an original document into the ADF tray or on the scanner glass.
2
From the home screen, touch Fax, and then enter the needed information.
3
Touch Darkness, and then adjust the setting.
4
Send the fax.

Printing a fax log

Note: Make sure that analog fax or etherFAX is configured. For more information, see the
printer to fax section.
1
From the home screen, touch Settings > Reports > Fax.
2
Touch Fax Job Log or Fax Call Log.

Blocking junk faxes

Note: Make sure that analog fax or etherFAX is configured. For more information, see the
printer to fax section.
1
From the home screen, touch Settings > Fax > Fax Setup > Fax Receive Settings > Admin Controls.
2
Set Block No Name Fax to On.

Holding faxes

Note: Make sure that analog fax or etherFAX is configured. For more information, see the
printer to fax section.
1
From the home screen, touch Settings > Fax > Fax Setup > Fax Receive Settings > Holding Faxes.
2
Select a mode.

Forwarding a fax

Note: Make sure that analog fax or etherFAX is configured. For more information, see the
printer to fax section.
1
Create a destination shortcut.
a
Open a web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address on the home screen. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
Setting up the printer to fax
Setting up the
Setting up the
Setting up the
Setting up the
170
section.