Table of Contents
Advertisement
Auto Start Operation
As shown in the following figure, this mode is applied to the device for starting the operation after the
specified time (hours) automatically. Note that the device does not stop the operation automatically.
Stop the operation by manual without fail.
SV
Set timer
Activate controller (Manual)
Setting of the Auto Start Operation
Turn on the power
1
FIXED TEMP
AUTO STOP
AUTO START
PROGRAM
STANDBY
END
HEATER
FUNCTION
PROGRAM
REFRIGE
2
Select operation mode
FIXED TEMP
AUTO STOP
AUTO START
PROGRAM
STANDBY
END
HEATER
FUNCTION
PROGRAM
REFRIGE
▼
Activate Timer
Start operation (Auto)
POWER
Standby
℃
2002/01/01 12:00
TROUBLE
MENU
ENTER
CANCEL
MENU
Auto-start OPR
℃
Select OPR mode
TROUBLE
MENU
ENTER
CANCEL
• Turn on the power switch of the unit (earth leakage
breaker). Pressing the POWER key turns on the
power.
The
temperature in furnace.
indicates "Standby" and the STANDBY lamp lights
on.
DEFROST
POWER
① Pressing the MENU key displays the operation
mode selection screen.
② The Sub Display on the operation mode selection
screen displays the name of operation mode
currently
selected
corresponding operation mode lamp blinks at the
same time.
③ Keep pressing the MENU key until the auto start
operation mode is displayed.
④ Press the ENTER key. The auto start operation
mode is decided.
DEFROST
The fixed temperature operation is selected at the
initial setting of unit. The operation mode carried
POWER
out last is selected in case other than it.
21
Operation Method
SV: Setting temperature
t: Time
t
Main
Display
indicates
The Sub Display
with
blinking.
the
The
Advertisement
Table of Contents
