Yamato IN602CS Instruction Manual page 36

Program Creation Example
11 Press the PROGRAM key to display the "Rep. start".
12 Press the ENTER key to display the repeat initiating step edition
screen. The cursor goes out and the setting for repeat initiating
step blinks.
13 Set the "No" using the "▼▲".
Press the ENTER key to decide the setting.
14
15 Press the PROGRAM key until the "Set TEMP" in the Step 2 is
displayed. The display on the lower column changes from "S01"
to "S02"or to "SO2 (un-used)".
16 Press the ENTER key to display the setting temperature edition
screen. The cursor goes out and the setting temperature blinks.
17 Set the temperature to 20
18 Press the ENTER key to decide the temperature.
19 Press the PROGRAM key to display the "Set time" selection
screen.
20 Press the ENTER key to display the setting period edition screen.
The cursor goes out and the setting period blinks.
21 Set the period to 0 min using the "▼▲".
22 Press the ENTER key to decide the period.
23 Press the PROGRAM key to display the "Rep. start".
24 Press the ENTER key to display the repeat initiating step edition
screen. The cursor goes out and the setting for repeat initiating
step blinks.
using the "▼▲"
℃
33
Operation Method
Rep. start ► No
S01
Rep. start No
S01
Rep. start ► No
S01
Rep. start ► No
S01
Set TEMP ► 0.0℃
S02
Set TEMP 0.0℃
S02
Set TEMP 20.0℃
S02
Set TEMP ► 20.0℃
S02
Set time ► 0min
S02
Set time 0min
S02
Set time 0min
S02
Set time ► 0min
S02
Rep. start ► No
S02
Rep. start No
S02