Auto Start Operation - Yamato IN604 Instruction Manual

Auto Start Operation

As shown in the following figure, this mode is applied to the device for starting the operation after
the specified time (hours) automatically. Note that the device does not stop the operation
automatically. Stop the operation by manual without fail.
SV
Set timer
Activate controller (Manual)
Setting of the Auto Start Operation
Turn on the power
1
Select operation mode
2
▼
Activate Timer
Start operation (Auto)
POWER
MENU
t
 Turn on the power switch of the unit (earth leakage
breaker). Pressing the POWER key turns on the
power. The Main
temperature in furnace.
indicates "Standby" and the STANDBY lamp lights
on.
① Pressing the MENU key displays the operation
mode selection screen.
② The Sub Display on the operation mode selection
screen displays the name of operation mode
currently selected
corresponding operation mode lamp blinks at the
same time.
③ Keep pressing the MENU key until the auto start
operation mode is displayed.
④ Press the ENTER key. The auto start operation
mode is decided.
 The fixed temperature operation is selected at the
initial setting of unit. The operation mode carried
out last is selected in case other than it.
22
Operation Method
SV: Setting temperature
t: Time
Display indicates
The Sub Display
with blinking.
the
The