Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Intertec Data Systems SL MINITHERM
Summary of Contents for Intertec Data Systems SL MINITHERM
- Page 1 Operating Instructions SL MINITHERM DBLA HOM146844171Ien-4 • 05/02/2020...
-
Page 2: Table Of Contents
www.intertec.info Table of contents 1 General .................................. 3 2 Use ................................... 3 3 Special conditions for safe use.......................... 3 4 Explanation of symbols for warnings and signal words .................. 3 5 Safety information .............................. 4 6 Installation accessories ............................ 4 7 Technical Data ................................ -
Page 3: General
Operating Instructions SL MINITHERM DBLA 5. Additional conditions for alternate use of thermostats General see concerning test certificate. They have to be sep- These operating instructions describe the safe and arately certified to the same standards. proper way to work with the device. The safety informa- 6. -
Page 4: Safety Information
Washer shape A 6.4 Rated voltage/Operating voltage Lock washers shape J 6.4 If one of the components listed here is not included in Illustration 1: Example: SL MINITHERM DBLA 70 T4 70 TS10 the scope of delivery, then please contact the manufac- label turer. -
Page 5: Installation
Operating Instructions SL MINITHERM DBLA Installation NOTICE Carefully remove When removing from the packaging and during trans- port, the connection line must not be stressed or bent. Free convection may not be impeded. You will find the minimum distances and installation position in the follow- ing figure. - Page 6 Operating Instructions SL MINITHERM DBLA supply as soon as the insulation resistance is no greater than 50 Ω per Volt of the rated voltage (refer also to ABNT NBR IEC 60079-14:2009). Junction ATTENTION: Never remove the adapter/ cable gland! Illustration 4: Example heater with KLE connection...
- Page 7 Operating Instructions SL MINITHERM DBLA Functional and safety test intervals can be freely selec- ted by the operator in accordance with the applicable regulations. Repairs may only be carried out by the manufacturer in the factory. All components have to be kept clean and free of dust...
-
Page 8: 15 Certificate Of Conformity
Operating Instructions SL MINITHERM DBLA If the information contained in this instruction manual NOTICE should not be sufficient in any way, then INTERTEC would be glad to be at your disposal to provide further in- Environmental damage may be caused if dis- formation and service.