FALCOM STEPP II Getting Started page 17

STEPP II GETTING STARTED VERSION 1.00
If download has been completed successfully, power down the Falcom
STEPP II (turn off the switches ACCU OFF, V+ and BOOT). Your
Falcom STEPP II is ready to run with the new firmware. The Falcom
STEPP II with the new firmware is automatically started at the next
power up (turn on the switches ACCU OFF, V+). A complete
configuration has to be done.
For further evaluation of the updated firmware in the FLSH memory of
target device, please refer to the corresponding documentation, which is
included on the delivering CD.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 16