When completed
When failed
46
Downloaded from
ManualsNet.com
: On
: Flashing
: On
: Flashing
: On
: Flashing
search engine
6.
Unit test starts.
The MODE LED starts flashing, and the 1 or 10 LED
starts turning on and off repeatedly in the sequence of
12481.
7.
The 1 or 10 LED stops turning on and off, and the
D LINK LED turns on when the test is completed.
• When completed successfully
The D LINK LED turns on, and the ERR. LED remains off.
• When failed
The following LEDs turn on.
Either the 1 or 10 LED
ERR. LED
D LINK LED
If the test fails, replace the Ethernet cable, and perform
the test again. If the test fails again, the possible cause
is a hardware failure of the head module.
Please consult your local Mitsubishi representative.