TXADD01 Timer
TXDEQ Timer
TANULL Timer
TCID Timer
Call Stagger
Display value
No Stagger
There is no delay between the call dialing of a BONDING session.
500 ms
Wait approximately ½ second between the call dialing of a BONDING session.
1 sec
Wait approximately 1 second between the call dialing of a BONDING session.
2 sec
Wait approximately 2 seconds between the call dialing of a BONDING session.
61200326L1-1A
equipment, it may be necessary to change this time so that it matches
TXADD01.
Write security: 3; Read security: 5
Specifies the length of time both endpoints wait for additional calls to be
connected at the end of negotiation before deciding that the BONDING call
has failed. The factory default setting is sufficient for most calls to connect,
although when dialing overseas it may be necessary to lengthen this timer
to allow for slower call routing.
Write security: 3; Read security: 5
Specifies the length of time both endpoints attempt to equalize the network
delay between the bearer channels before deciding the BONDING call has
failed.
Write security: 3; Read security: 5
Specifies the length of time the answering endpoint attempts to detect the
BONDING negotiation pattern from the originating endpoint before decid-
ing the BONDING call has failed. It may be necessary to shorten this timer
if the DTE equipment using the BONDING module also has timer con-
straints for completing non-BONDING parameter negotiation.
Write security: 3; Read security: 5
Specifies the length of time both endpoints attempt to negotiate an agree-
able value for bearer channels and channel capacities before deciding the
BONDING call has failed.
Write security: 3; Read security: 5
Specifies the amount of delay between placing calls for outgoing BOND-
ING sessions. Table 3-2 defines the call stagger values.
IMUX-56/64 Module User Manual
Table 3-2. Call Stagger Values
Meaning
Chapter 3. Operation
3-3